Design Center
[103] Custom Inductors – Applying the ONE Design Equation
Dr. Ray Ridley continues his discussion on the ONE design equation.
[102] Custom Inductors – ONE Design Equation
Dr. Ray Ridley discusses his introduction into Power Electronics. An early foray into design optimization software revealed a curious fact about magnetics design - there is only ONE design equation that must be obeyed.
[101] Magnetics Design – Simple or Complex?
What do you need to build good magnetics? A PhD, or practical experience?
[100] Magnetics Design Part I - Standard or Custom?
Magnetics represent the most ancient of technologies used in modern electronics systems.
[099] Modern Magnetics Design
This article gives an example of how profound proximity effects can be.
[098a] Vorperian's Coupled-Sepic Analysis Notes
Dr. Vorperian's hand-written analysis of the tightly-coupled sepic converter.
[098] Small Signal Modeling of the Tightly-Coupled Sepic Converter
Dr. Vorperian's analysis of the tightly-coupled sepic converter.
[097] Linear Circuit Model for Predicting Magnetics Winding Proximity Losses
A linear circuit model is derived which will show complex proximity effect losses for arbitrary waveforms.
Switching Power Supply Primer Part II
Switching Power Supply Primer Part II
Read full articleSWITCHING POWER SUPPLY PRIMER PART I - WHY BUILD A SWITCHING POWER SUPPLY?
SWITCHING POWER SUPPLY PRIMER PART I - WHY BUILD A SWITCHING POWER SUPPLY?
Read full articleTrends In High Frequency Magnetics Part 4 Circuit Design
Trends In High Frequency Magnetics Part 4 Circuit Design
Read full articleTrends In High Frequency Magnetics Part 3 Core Loss
Trends In High Frequency Magnetics Part 3 Core Loss
Read full articleTrends In High Frequency Magnetics Part 2 Core Saturation
Trends In High Frequency Magnetics Part 2 Core Saturation
Read full articleTrends In High Frequency Magnetics Part 1 Introduction
Trends In High Frequency Magnetics Part 1 Introduction
Read full articleAP300 - The Industry's Only Full-Featured Analyzer
AP300 - The Industry's Only Full-Featured Analyzer
Read full articleFrequency Response Analysis Part IV -- Power Supply Loop Measurement
Frequency Response Analysis Part IV -- Power Supply Loop Measurement
Read full articleFrequency Response Analysis Part III -- How much signal do you need?
Frequency Response Analysis Part III -- How much signal do you need?
Read full articleFrequency Response Analysis Part II - What frequency range do you need?
Frequency Response Analysis Part II - What frequency range do you need?
Read full articleFrequency Response Analysis Part I - Why do you need it?
Frequency Response Analysis Part I - Why do you need it?
Read full article