Circuit Designs
[A23] PFC Small-Signal Analysis
Average Small-Signal Analysis of the boost power factor correction circuit. Originally published 1987 in a VPEC Seminar.

Power Supply Design Center Facebook Archives
In this article, we have all of the Power Supply Design Center posts from Facebook, archived by Bob Gudgel.

Featured Article: [111] ZVS full-bridge converter employing an active snubber
The ZVS full bridge converter can be enhanced greatly by implementing an active snubber on the secondary side of the transformer.

Featured Article: [A24] Flyback Snubber and Clamp Design
In this article, we will talk about practical design techniques for the most commonly used snubber and clamp circuits for the flyback converter.

[A24] Flyback Converter Snubber Design
In this article, we will talk about practical design techniques for the most commonly used snubber and clamp circuits for the flyback converter.

[112] The Power of Dowell’s Equations and Curves
The standardized curves of Dowell’s equations are a superb tool for designing better high-frequency magnetics. A careful balance of layer count and wire or foil count is needed to reach an optimum design.

[110] Multi-Loop Control for Quasi-Resonant Converters
Very high frequency quasi-resonant converters can benefit from current mode control. Different techniques are used to generate clean waveforms at up to 10 MHz.

[109] The Rebirth of the Electric Car
In 2005, all of the major car manufacturers gave up on their electric programs. They were jolted awake again by Tesla who commercialized the TZero technology. You can also read about why the hydrogen economy is a non-starter.

[A22] Magnetics Proximity Loss
Proximity Loss in Magnetics Windings.

[A21] Designing with the TL431
The first-ever proper analysis of the popular TL431 controller.

[A11] Gate Drive Design Tips
The right way to drive you power circuit mosfets for safety and ruggedness.

[071] Designing Snubbers for Nonisolated Converters
How to design snubbers when you don't know the inductance causing the ringing.

[068] Flyback Converter Development Part V - Control and Loop Gain
Flyback converter control and loop gain testing.

[067] Flyback Development Part IV- Current Sense, Snubbing, Regulation
Flyback design transformer and full power testing.

[066] Flyback Development Part III - Rectifier and Transformer Design
Flyback input rectifier and transformer design.

[065] Flyback Development Part II - Initial Testing
Flyback design bias and control circuit testing with high voltage.

[064] Flyback Development Part I - Specification and Circuit Design
Flyback design specifications and architecture.

[052] Designing a Two-Stage Output Filter for Low Output Impedance
How to arrange the components of your second-stage output filter for optimum performance.

[041] Forward Converter Design - Part VIII Testing Schedule
Testing and development schedule for the forward converter.

[040] Forward Converter Design - Part VII Full Power Cross-Regulation
Initial full-power testing of the forward converter.
